Del ozone Spa-Eclipse Manual de instalación descargar pdf (Pagina 5)

Eclipse Installation & Operations Manual

near the top on the left and right and one located in the center

near the bottom. Refer to Figure 1 for clarification.

2. Install screws (or other hardware appropriate for the mounting

surface) through the two mounting holes near the top of the

enclosure. Install the last screw through the mounting hole

near the bottom of the enclosure. Mounting hardware must be

driven until the head fully contacts the enclosure wall. Mounting

hardware head must not be smaller than 0.25 inches (6.3 mm) in

diameter and the threads of the hardware must be smaller than

0.25 inches (6.3 mm) in diameter.

2C. Electrical

2C-1. Main Power

This device is intended to be installed by a certified electrical

technician, in accordance with local electrical codes. Connect

the DEL Eclipse to the pool timing clock so that the DEL Eclipse

operates simultaneously with the pool pump. The DEL Eclipse has

three available Knockouts for a 1/2” conduit fitting, two on each

side and one on the back. Remove only the ideal Knockout and

install the proper conduit fitting. Open the Enclosure and locate the

Terminal Block. Connect Line 1, Line 2, and Ground to the Terminal

Block as indicated by the label on the inside of the enclosure

door. Refer to the IMPORTANT SAFETY INSTRUCTIONS at the

beginning of this manual for important wiring information.

2C-2. Earth Grounding Lug

Using an 6 AWG (13.3 mm

) conductor, connect the Grounding lug

on the bottom of the DEL Eclipse, marked to an appropriate earth

contact.

2D. Plumbing

Ozone gas is introduced to the pool circulation line using a venturi

injector. Suction developed by the venturi allows the DEL Eclipse

generator to operate safely under vacuum.

Note: Water must not travel back to the ozone generator.

Mounting the unit above the water line and scheduled check valve

replacement will keep water from entering the DEL Eclipse.

2D-1. Plumbing the Injector Manifold

The Injector Manifold must be installed in the pool’s main return line

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

Del ozone Spa-Eclipse Manual de instalación Pagina 5